Use and Care Guide
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
30
Checking the parts:
11. Installation
You will also need the following tools:
1. Electric drill
2. Masonry drill bit & anchors (only required if installing
the range on a stone or concrete oor)
3. Steel tape measure
4. Phillips head screwdriver
5. Flat head screwdriver
6. 2.5 mm Allen key (supplied with the range)
7. Spirit level
8. Open-end or adjustable wrench
9. Pencil and ruler
10. Pipe wrenches
Additional materials you may need:
• Gas line shut-off valve.
• Pipe joint sealant or UL-approved pipe thread tape with
Teflon* that resists action of natural and LP gases.
• Flexible metal appliance connector (½’’ I.D.). A 5foot
length is recommended for ease of installation but
other lengths are acceptable. NEVER use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(¾’’ or ½’’ NPT x ½’’ I.D.).
• Flare union adapter for connection to pressure regulator
on range (½’’ NPT x ½’’ I.D.).
• To protect any floor covering under the range, use a
sheet of ¼’’ thick plywood or equivalent large enough to
stand the range on.
6 grates page 37
Allen key
ArtNo280-0084 DF Pan Supports
1 broiler rack with telescopic
runners
2 at racks with telescopic runners
ArtNo.326-0014 - Cradle rack (Falcon)
2 broiler pans with grids Control knob (°C)
ArtNo.331-0008 - 90SC
grill pan & trivet
Griddle (Optional Extra) Wok cradle (Optional Extra)
2 sets of side supports
Toe kick page 37
ArtNo.350-0007 - Plinth USA
2 side panel extensions page
34
Anti-tip device page 34
ArtNo.351-0001 - Side extension
panel USA
Conversion kit from natural gas to
propane gas (kit number A060048)
page 40
ArtNo.020-0019
Conversion Kit USA
*Teon: Registered trademark of DuPont