Dimensions Guide
AGA Rangehood – 44"
Model # AMCHD44
2
Width 44"
Height
18 
5
/
16
" – 30 
5
/
16
"
Standard
Technical Specifi cations
Vent Hood Width
43 
5
/
16
"
Duct Cover Width
8 
1
/
4
"
Vent Hood Height
9 
7
/
16
"
Duct Cover Minimum Height
18 
5
/
16
"
Duct Cover Maximum Height
30 
5
/
16
"
Duct Cover Depth
8 
1
/
4
"
Electrical Requirements
120v, 60hz, 15amps
Warranty 1 Year Limited 
Warranty on all 
parts and labor
• The manufacturer will not be held liable for any 
damages resulting from incorrect or improper installation.
• Check that the main voltage corresponds to that 
indicated on the rating plate fi xed to the inside of the hood.
• The electrical supply must be properly and suffi ciently 
grounded.
• Connect the extractor to the exhaust fl ue through a pipe of 
minimum diameter 6". The route of the fl ue must be as short 
as possible.
• Do not connect the extractor hood to exhaust ducts carrying 
combustion fumes (boilers, fi replaces, etc.).
• If the extractor is used in conjunction with non-electrical 
appliances (e.g. gas burning appliances), a suffi cient degree 
of aeration must be guaranteed in the room in order to 
prevent the backfl ow of exhaust gas. The kitchen must have an 
opening communicating directly with the open air in order to 
guarantee the entry of clean air.
Use
• The range hood has been designed exclusively for domestic 
use to eliminate kitchen odors.
• Never use the hood for purposes other than for which it has 
been designed.
• Never leave high naked fl ames under the hood when it is in 
operation.
• Adjust the fl ame intensity to direct it onto the bottom of the 
pan only, making sure that it does not engulf the sides.
• Deep fat fryers must be continuously monitored during use: 
overheated oil can burst into fl ames.
• The hood should not be used by children or persons 
not instructed in its correct use.
HOOD BODY
TELESCOPIC 
CHIMNEY
Installation
Specifi cations are subject to change without notice. Visit www.aga-ranges.com for the most up-to-date information.
Optional 24" chimney extension replaces the upper 
half of the two piece chimney which will give you a 
maximum of 41" height - Part# SAG-620000496



