Use and Care Guide
42
INSTALLATION
Check the appliance is electrically safe when you have nished.
Provide proper electrical supply
This range must be supplied with 240 V 60 Hz, and connected
to an individual, properly grounded branch circuit protected
supply. If the electrical service provided does not meet the
above specications, it is recommended that a licensed
electrician install an approved outlet.
This should be connected to an appropriate Branch Circuit
protected supply. NOTE - load diversity factor has been
applied in accordance with NFPA 70 article 220.
Connecting using the supplied cord and
plug
Your range is shipped with a 4-prong NEMA 14-50P plug to
be used in a NEMA 14-50R receptacle.
Recommended electrical outlet location
When connecting using a NEMA 14-50R receptacle, if possible
position it so it can be accessed through the opening at the
rear of the drawer cavity (Fig. 14.1). Alternate location within
the shaded area in (Fig. 14.2). The distance between the back
of the range and the wall is approximately 4” (10.6 cm).
Plug the range power cord into a properly grounded wall
receptacle.
Disconnect the electrical supply before servicing.
8”
12”
12”
12”
Fig. 14.1
Opening inside the drawer cavity
Fig. 14.2