User and Care Manual
40
INSTALLATION
Check the appliance is electrically safe when you have nished.
Reassemble
1. If you have lifted the maintop, carefully lower it onto
the range. The burners are protected against the burner
ames going out by Flame Supervision Devices (FSD’s).
2. Take care when lowering the maintop to locate the FSD
sensor probes (Fig. 12.8) in their holes in the cook top
and the burner bases.
3. Ret the control panel and the knobs.
Gas Regulator
NOTE: To avoid exterior damage to the storage drawer. Place
a soft cushioned mat on the oor.
Removing the Storage Drawer
1. Pull the drawer out to its furthest point.
2. Push the ends of the plastic clips (Fig. 12.9 and Fig.
12.10) to release the catches holding the drawer to the
side runners. At the same time pull the drawer forward
and away from the side runners.
3. For safety make sure the drawer runners are out of the
way. The regulator is now accessible (Fig. 12.11).
4. Unscrew the hexagonal nut in the front of the regulator.
The regulator nut has a plastic snap-in converter device
on the underside (Fig. 12.12). To convert the regulator
snap the device out of the nut and replace the other
way up.
5. The snap-in converter device is marked to show which
gas it is set for (Fig. 12.13). Make sure the device is
secure in the base of the nut and replace the nut to the
regulator.
ArtNo.102-0007 - Maxitrol converter device positions
ArtNo.103-0006 - Maxitrol cap & converter
Nut
Snap-in converter device
ArtNo.102-0005 - Gas regulator types
Fig. 12.8
Fig. 12.9
Down on the left-hand side.
Up on the right-hand side
Fig. 12.11
Fig. 12.12
Fig. 12.13
Fig. 12.10