Owner's Manual

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
27
ArtNo.280-0070 - Side extension A
ArtNo.280-0071 - Side extension B
ArtNo.281-0004 - 90SC
- Fitting the side panel
ArtNo.281-0005 - Albertine SC
- Side panel in place
Wall fixing
Where oor xing is impractical and provided that the outer
anti-tip bracket can be attached to a solid wall, the anti-tip
device may be attached to a wall (Fig. 9.15). Make sure to use
suitable screws and xings.
Side panel extension kit (optional extra)
Two side extension panels are supplied with the range. These
can be installed where the side of the range is exposed. The
extension installation must be performed by a qualied gas
installer, preferably during installation of the appliance
(Fig. 9.16).
Kit Contents:
Side panel extension 2
M5 screw 4
M5 nut 4
Large washer 4
Shakeproof washer 4
Procedure
Place a screw and washer in the top hole in the rear edge of
the range side panel. Add a shakeproof washer and start the
nut on the screw threads so that the screw is loosely held in
place. Repeat with the other hole (Fig. 9.17).
Slide the side extension in from the side behind the washers
(Fig. 9.18).
Tighten the top and bottom screws to hold the side extension
in place.
Reposition the range making sure the anti-tip device is re-
engaged properly when the range is replaced. Failure to take
this precaution could result in tipping of the range and cause
injury.
NOTE: Check that the extension panel does not foul the
mains lead or gas connection when the range is pushed back
Reconnect the electricity supply.
Fig. 9.15
Fig. 9.16
Fig. 9.17
Fig. 9.18
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting
Outer anti-tip
bracket
Range
1/8” (3mm) min
Wall
Outer anti-
bracket
Range
Floor