Installation instructions

42
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
The two end caps (one each end) of the
standard rear fl ue grille must fi rst be removed.
They are held in place by two fi xing nuts on the
inside face.
Remove the two fi xing screws (3mm hexagonal
socket head) and nuts that pass through the top
of the rear fl ue grille.
Hold the spacer in position. From below the rear
fl ue grill use the 2 screws to fi x the spacer in
position.
Fit the new end caps to the rear spacer and fl ue
grille and hold in place with the nuts and spring
washers supplied.
Screw the rear stays to the range back. Note:
the stays are of different lengths.
If you are not fi tting the splashback the
splashback mounting holes can be blocked with
the extra screws supplied.
Fit the splash back (optional)
If the rear spacer is not fitted.
Remove the two fi xing screws (3mm hexagonal
socket head) and nuts that pass through the top
of the rear fl ue grille. Hold the splash back in
position.
From the rear refi t the 2 fi xing screws and nuts.