Owners Manual

Fig. 6.13

Fig. 6.14

8. Using the stay rod nut adjusting tool, carefully lower

the top plate adjusting nuts until the top plate sits at

the required height, making sure that the top sits level

and matches the height of the AGA Total Control / Dual

Control (see Fig. 6.13).

For servicing requirement, top plate should be removed by

raising adjusters approximately 1/4” (5mm), the top plate

can now be removed easily without causing damage to the

enamelled surfaces.

When removing the top plate, the switch wiring harness

should be disconnected from the main wiring harness at the

connection point located at the front left hand side of the

appliance, beneath the formex cover sheet.

DESN 516555

DESN 516883

9. Fit the handrail bracket over the fixing stud located on

the top plate. Lock into position by tightening the grub

screw nearest the appliance (see Fig. 6.14).