Owners Manual

Fig. 6.11
Fig. 6.12
17
DESN 516552
DESN 516554
6. Slide hotcupboard onto plinth until rear tongue bracket
engages fully into rear of base slot, (see Fig. 6.11).
Ensure the appliance is aligned squarely with the plinth
then proceed to engage the front tongue bracket into
the slot on the underside of the base plate.
Once satisfied that the front tongue bracket is engaged
fully lock it into place by tightening the two M6 screws
fully. Ensure that the electrical cable does not come into
contact with oven vent pipe from the AGA Total Control/
Dual Control.
7. The hotcupboard top plate is set 1/4” (5mm) higher than
the AGA Total Control / Dual Control top plate. This is
to prevent damage to the enamel during installation.
Lower the top plate using the adjusters
(see Fig. 6.12 and Fig. 6.13).