Owners Guide Natural Gas Models

16
Burner Controls
Fig. 4
To Light the Burner
Lighting Procedure - See Figs. 4 - 10
1. The main burner gas flow is set with the oven
thermostat control knob (See Fig. 4). First ensure
both knobs are turned fully clockwise. Oven gas
control knob to the OFF position oven thermostat
control knob to the minimum setting (thin end of white
band).
2. Turn oven gas control knob slightly anti-clockwise
towards the ignition position ( ) until reaching stop,
press down and hold for 5 seconds. (See Fig. 6).
3. Continue pressing down knob while turning
further anti-clockwise to the ( ) position (See Fig.
7) (this activates the spark ignitor) continue to hold
down for 10 seconds after flame supervision burner
has been lit. (If the it does not light, steps 2 and 3
can be repeated, this can be viewed through the
viewing window.
4. Upon lighting, release knob and turn further anti-
clockwise to the ( ) symbol (See Fig. 8). Main
burner gas flows according to the thermostat setting.
5. Turn the oven thermostat control knob slightly anti-
clockwise into the white band (LOW FIRE position)
(See Fig. 9). Leave in the low fire position for at least
60 minutes.
NOTE: Low fire position is attained by turning oven gas
control knob gradually into the white band until small
flame along main burner is observed through viewing
window.
6. After 60 minutes rotate control knob anti-clockwise to
the mid-position of the green band for normal running
(See Fig. 10).
NOTE: It will take up to 24 hours for all ovens to reach
operating temperature, the oven heat indicator may
display green before this (refer to page 12 regarding
heat indication display). Once the oven temperatures are
at operating temperature it may be necessary to make
fine adjustment to the oven control knob to achieve
the desired temperatures. It is not advisable to make
further changes to the control knob once the desired
temperature is achieved.
When the range is lit from cold, moisture may form
on the enamel which should be wiped off to prevent
staining.
IF THE FLAME HAS EXTINGUISHED FOR ANY
REASON, WAIT THREE MINUTES (MINIMUM) AND
REPEAT THE LIGHTING PROCEDURE.
To Extinguish the Burner
1. Turn oven gas control knob clockwise until reaching
stop ( ) position.
2. Press down slightly and continue turning clockwise
from ( ) position to the OFF position (See Fig. 7)
When the burner has cooled sufficiently, lighting
procedure may be repeated.
Power Failure
In the event of power failure the ovens on your range will
continue to work. The hotplates will not, but will when
power has been restored.
Hotplates
control knob
Oven thermostat
control knob
Oven heat
indicator
Oven gas
control knob
Viewing
window