Installation Instructions

23
4. Run a straight edge along the front of the AGA Dual Control plinth, to ensure the front face of both plinths sit squarely
against the straight edge. (See Fig. 18)
When satisfied both plinths sit squarely, jacking screws can be tightened until they just make contact with the AGA
Dual Control plinth, and locking screws can now be tightened.
Fig. 18 DESN 516551
USE STRAIGHT EDGE ACROSS BOTH PLINTHS TO ENSURE PLINTHS ARE ALIGNED
SQUARELY
Fig. 19 DESN 516553
5. Front jointing bracket can now be hooked into place over the two pot magnets. This will latch the two plinths together.
(See Fig. 19)