Installation Guide

10
1. Fit the handrail bracket over the fixing stud located on the top plate. Lock into position by
tightening the grub screw nearest the appliance. (See Fig. 5).
Fig. 5 DESN 516883
AGA DC3 HANDRAIL CONNECTION
2. Next the handrail, endcaps and handrail require assembly.
Slide the handrail through the handrail brackets.
Fig. 6 DESN 516880
AGA DC3 HANDRAIL CONNECTION
3. Once the handrail assembly is located squarely, lock the handrail in position by winding in
the grub screws on the underside of each handrail bracket.
4. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be
carefully pushed into place until they sit flush with the outside face of each bracket (a light
smear of lubricant such as, washing up liquid on the end cap ‘O’ rings may ease fitment.
5. Finally, fit the plinth facia to the magnets on the front of the plinth. Make sure that the
plinth facia is centrally located and does not overhang the range.
Commission the AGA Dual Control, as stated in the relevant Installation Instructions and carry
out functional test on each of the features of the AGA Dual Control.