Installation Instructions
16
Fig. 12 DESN 516552
7. The hotcupboard top plate is set
1
/4” (5mm) higher than the AGA Dual Control top plate. This
is to prevent damage to the enamel during installation. Lower the top plate using the
adjusters (See Figs. 13 & 14).
Fig. 13 DESN 516554
6. Slide hotcupboard onto plinth until rear tongue bracket engages fully into rear of base slot,
(See Fig. 12). Ensure the appliance is aligned squarely with the plinth then proceed to
engage the front tongue bracket into the slot on the underside of the base plate. Once
satisfied that the front tongue bracket is engaged fully lock it into place by tightening the two
M6 screws fully. Ensure that the electrical cable does not come into contact with oven vent
pipe from the AGA DC3.
1
/4” (5mm) HEIGHT
DIFFERENCE