Installation Guide

8. Using the stay rod nut adjusting tool, carefully lower the top plate adjusting nuts until the top

plate sits at the required height, making sure that the top sits level and matches the height of

the AGA DC3 (See Fig. 14).

For servicing requirement, top plate should be removed by raising adjusters approximately

/4” (5mm), the top plate can now be removed easily without causing damage to the

enamelled surfaces.

When removing the top plate, the switch wiring harness should be disconnected from the

main wiring harness at the connection point located at the front left hand side of the

appliance, beneath the formex cover sheet.

Fig. 14 DESN 516555

9. Fit the handrail bracket over the fixing stud located on the top plate. Lock into position by

tightening the grub screw nearest the appliance. (See Fig. 15).

Fig. 15 DESN 516883