Installation Guide

4
GENERAL NOTES
NOTE: THESE INSTALLATION INSTRUCTIONS SHOULD BE LEFT WITH THE RANGE AND
THE USER TO RETAIN FOR FUTURE REFERENCE.
Before installation of an AGA can be made, the site is inspected for suitability by an authorized
AGA distributor and corrected where necessary to conform with local or regional electrical codes.
DELIVERY REQUIREMENTS
The AGA DC3 arrives on 1 pallet.
There must be access to the kitchen to manipulate a foot print of 39
9
/16” (1005mm) x 29
1
/8”
(740mm). A wooden template (skate with castor wheels) of dimensions 39
9
/16” (1005mm) x
29
1
/8” (740mm) could be used to check if the AGA Dual Control fully built appliance is able to
fit through the property grounds and doors into its installation position in the kitchen. It must
also be considered that the height of the appliance is 37
3
/4” (960mm) off pallet and 43
1
/4 ”
(1100mm) on the pallet, so high level obstacles/restrictions must not be overlooked.
GENERAL INSTALLATION REQUIREMENTS
The installation of the range must be in accordance with the relevant requirements of the local
Wiring and Building Regulations. It should be in accordance also with any relevant requirements
of the local or state codes.
In your own interest and that of safety to comply with the law, all appliances should be installed
by an authorized AGA distributor in accordance with the relevant regulations.
CAUTION:
THIS UNIT IS HEAVY, PROPER EQUIPMENT AND ADEQUATE
MANPOWER MUST BE USED IN MOVING THE RANGE TO
AVOID DAMAGE TO THE UNIT OR THE FLOOR