Troubleshooting guide

Figure 19

4. Mount the regulator to the CO2 tank (connection )

use the new plastic washer you recieved from the gas

supply company. Note that the regulator has left hand

threads and has to be turned counterclockwise to

tighten. Tighten with the adjustable wrench or the 1

⁄8"

open end wrench.

5. Insert the barbed end on the keg coupler into the red

gas line(s) and seal with a plastic hose clamp. (connec-

tion ).

6. Verify that the black rubber washer is in the 90° brass

elbow and screw the elbow onto the top of the keg

coupler. (connection ).

7. Place a black washer into the stainless steel end tting

of the clear beer line from the tower and screw onto the

90° elbow on top of the keg coupler. (connection ).

8. Locate the CO2 tank in the corner of the refrigerator as

shown in Figure 19 and secure with the chain.

9. Hooking up the coupler to the keg. Verify the white

handle is in the up position as shown. Line up the dog

ears on the keg neck with the opening in the coupler.

Twist the coupler clockwise ↷ until it stops. Extend the

white handle and push down to lock.

USING YOUR REFRIGERATOR

Chain

Figure 20

Dog ears on keg

Handle in up position