Specifications

21
another external CRT. If your PC system Functions properly
with a CRT Monitor but it does not function with the LCD
Monitor, the output timing of the VGA card may be out of
the LCD’s synchronous range. Please change to an
alternative mode listed in the Supported Timing List or
replace the VGA card, and then repeat steps 1and 2.
There is no picture on LCD Monitor If you have chosen an output timing that is outside of the
LCD Monitor’s synchronous range (Horizontal: 24~80KHz
and Vertical: 49~75Hz), the OSD will display a “Out of
Range” message. Choose a mode that is supported by
your LCD Monitor.
Also, if the signal cable is not connected to LCD monitor at
all or properly, the monitor screen will display a message
“No Input Signal”.
After the USB equipment inserted
into the Monitor USB Port,
Windows could not detect it.
Because one of the USB ports on the monitor has the
function of "USB Power Charger", namely only provide the
electricity for the equipment such as charger, etc. If you
have USB Flash Disk, USB Hard Disk or such kind of
equipment needing to connect to operating systems such
as Windows, etc., please insert them to the standard USB
ports which have the symbol of
. If you still can not
connect to the operating system, you can try to insert this
equipment in the jack (usually near the keyboard jack) on
the computer directly.
A little pattern which is like an eye
often appears on the corner of my
screen. And sometimes the color of
my screen will become light green.
The iRelax Eye Reliever one function for protecting user’s
health is stored in the monitor, so the little eye pattern that
you see is Eye Blink which reminds you should rest your
eyes. The Eye Release which the screen turns green some
times, is to remind you to leave the seat and have a rest.
You can close the function by select the option in the OSD
menu.
Can not display the OSD menu of
the monitor.
To avoid others to alter the setting values of the monitor, the
lock function of the OSD menu has been designed. When
the monitor is power-off, you only need to press the Up and
Down buttons at the same time and then turn on the
monitor. Keep pressing the Up and Down buttons for about
5 seconds until the words “Key Unlock” appear and then
you can alter the setting values of the monitor.