User guide

Setup Wizard
24 GeoSteer System
Set RTK Radio Modem Channel or Frequency
If the GeoSteer detects a GS-900 or GS-450 Radio Modem, the user will be prompted to enter a channel or frequency to match
the channel or frequency of the transmitting Base Station. Press the Change Frequency or Change Channel button to set this
value.
Figure 2-4 Set RTK Radio Modem Channel or Frequency
Use the keypad shown in Figure 2-5 to enter the channel or frequency used on the Base Station. After the channel has been set
press the Green Check Mark button to save the setting. Press the Red X button to cancel.
Figure 2-5 Change Radio Channel or Frequency
After the channel or frequency has been set, press the Blue Right Arrow button shown in Figure 2-4 to continue to the next
step.