User guide

Setup Wizard
Operator’s Manual 23
Figure 2-2 WAAS/EGNOS Initial Setup Screen
The GeoSteer system can detect and simultaneously track two separate WAAS or EGNOS PRNs. If the Primary PRN becomes
unavailable, the system will automatically switch to the Secondary PRN. To change either of the PRNs to a different satellite,
press the Change Primary or Change Alternate button. Refer to the WAAS or EGNOS websites to determine satellite
availability and health for your location.
Use the keypad shown in Figure 2-3 to enter the Primary or Secondary WAAS/EGNOS PRN number. After the PRN has been
set press the Green Check Mark button to save the setting. Press the Red X button to cancel.
Figure 2-3 PRN Number Change
After both PRN values have been set, press the Blue Right Arrow button shown in Figure 2-2 to continue to the next step.