User guide

Transferring GeoSteer from Vehicle to Vehicle
10 GeoSteer System
Figure 1-8 AutoSteer Setup Opening Screen
The five folder tabs along the top of the screen separate the GeoSteer configuration and monitoring functions into sub groups
to simplify management. The five tabs and the options for each are shown below:
VEHICLE SYSTEM GPS CONNECTIONS MY ACCOUNT
Setup Wizard System Health RTK Cell Modem Call Support
Manage Vehicles Manage Settings OmniSTAR External Radio Details
Auto Calibrate Accessories WAAS/EGNOS Feature Code
Steering Adjust Technician Precision Settings
Steering Components Software Upgrade NTRIP
Planning Tools
GPS Diagnostics
NMEA Out
Each of these tabs is described in detail in the following chapters. For more information about each feature shown above, refer
to the corresponding chapter.
Transferring GeoSteer from Vehicle to Vehicle
The GeoSteer system is designed to be easily transferred from vehicle to vehicle. Specific vehicle kits are available that can be
installed on each vehicle so that only the Display, GeoSteer Control Unit, and GeoDock need to be transferred from vehicle to
vehicle. Each vehicle that the GeoSteer system is to be transferred to should have the Display Harness, Power Harnesses,
Vehicle Harnesses, and GeoDock Harnesses already preinstalled. Contact your AutoSteer dealer for information about
obtaining and installing additional vehicle specific kits. Use the instructions in the section to transfer the GeoSteer system from
one vehicle to another.