User guide

RTK
98 GeoSteer System
Change Frequency
1. Press the Change Frequency button.
2. Manually enter a new Frequency number using the numeric keypad and select the proper Channel Spacing.
Note: The Channel Spacing must be 12.5 kHz or 25 kHz. This must match the channel spacing on the Base Station radio
modem.
3. Press the Green Check button to save the new frequency setting or press the Red X to cancel.
Figure 4-9 Entering RTK Radio Frequency
Use Previous
1. Press the Use Previous button.
2. Use the Gray Up/Down Arrow or directly select one of the previously used radio channels.
3. Press the Green Check button to save the new channel setting or press the Red X to cancel.
Figure 4-10 Using a Previous Radio Frequency