Getting Started Guide Instruction Manual
EZ-Guide Plus Lightbar Guidance System Getting Started Guide Getting Started 19
Path Display on the Summary screen
The following table shows the effect of the Path Display settings on the Summary
screen:
Setting the antenna offset
By default, the antenna is assumed to be at the
implement position. If the antenna is not
mounted at the implement position, to ensure
correct guidance, set an antenna offset using
Lightbar / Ant/Impl. Offset.
C
CAUTION — The antenna must be mounted on the vehicle centerline. Otherwise,
offline guidance will not be correct.
Coverage area
Coverage area is calculated whenever the spray switch is connected and on. For
information on connecting a spray switch, see
Connecting to other devices, page 12.
By default, Coverage Area is displayed on the Status screen. To display Coverage Area
on a map view instead, select Lightbar / Status Text.
B
Tip — To save the coverage area value, you must Pause before turning off the
system. Otherwise the value will be lost when you restart the system.
If you load an existing AB Line with a coverage area value, you can choose to add to
the value, or reset to 0.
Item Description
Off Coverage is not displayed
On Coverage is displayed wherever the vehicle drives
Switch Coverage is displayed when it is enabled by an external switch
Engaged Coverage is displayed when the EZ-Steer system is engaged
EZ-Boom Coverage is displayed where the EZ-Boom 2010 system sprayed
Vehicle centerline
Antenna offset
ahead of
Implement
implement