Installation User Manual

ManualsBrandsAg Leader ManualsEquipmentEZ-Guide Plus Cable – Keypad, Radar, Switch

Ag Leader Technology

Cable – Keypad, Radar, Switch

Ez-Guide Plus / 500 Installation Instructions

PN: 2005898 Rev A – June 2007 1

The Keypad Splitter Cable with Implement Switch (pn: 4001225-1) can be used for

multiple connections to the EZ-Guide Plus and EZ-Guide 500 Lightbars. This cable will

connect to the DB9 serial port on the back of the EZ-Guide plus or EZ-Guide 500.

Connections include:

• Keypad input

• Implement Switch input

• GPS signal output

• Radar speed output

Note: The Pulse Amplifier is only needed when connecting radar output to an external

device requiring radar speed. Only Raven, Hiniker and Dickey John monitors are

supported devices.

Summary of content (5 pages)

PAGE 1
Ag Leader Technology Ez-Guide Plus / 500 Cable – Keypad, Radar, Switch Installation Instructions The Keypad Splitter Cable with Implement Switch (pn: 4001225-1) can be used for multiple connections to the EZ-Guide Plus and EZ-Guide 500 Lightbars. This cable will connect to the DB9 serial port on the back of the EZ-Guide plus or EZ-Guide 500.
PAGE 2
Ag Leader Technology Ez-Guide Plus / 500 Cable – Keypad, Radar, Switch Installation Instructions Enabling the implement switch in EZ-Guide Plus From the run screen, arrow down to the config menu (wrench icon) and press OK. Arrow down to the “Lightbar” menu and press OK. Arrow down to “Display Config” and press OK. Press OK until Path Display is highlighted. Arrow down until “Switch” is displayed The EZ-Guide Plus will now log coverage area when the implement switch is triggered.
PAGE 3
Ag Leader Technology Ez-Guide Plus / 500 Cable – Keypad, Radar, Switch Installation Instructions Enabling Implement Switch with EZ-Guide 500 From the run screen, arrow down to the config menu (wrench icon) and press OK. Arrow down to “System” and press OK. Arrow down to “Guidance” and press OK. Arrow down to “Coverage Logging” and press OK.
PAGE 4
Ag Leader Technology Ez-Guide Plus / 500 Cable – Keypad, Radar, Switch Installation Instructions Arrow down to “Switch” and press OK. The EZ-Guide 500 will now log coverage area when the implement switch is triggered. Mounting the Implement Switch 1. Decide on a location for mounting the implement switch. 2. When installing the implement switch, the switch must be mounted so that the lever is in the off center position when the implement is in the application position.
PAGE 5
Ag Leader Technology Ez-Guide Plus / 500 Cable – Keypad, Radar, Switch Installation Instructions 3. If the switch cannot be mounted this way, then the wiring in the switch must be changed. To do this, first open the switch casing. 4. Loosen the screws holding the green and black wires. 5. Remove the green wire from pin-13 and move it to pin-21 and secure it there with the screw 6. Remove the black wire from pin-14 and move it to pin-22 and secure it there with the screw.