Users Manual User Manual

33
GPS
- If the Fast Update Rate is ON, then your receiver is capable of outputting an update rate faster than 1
Hz per second.
- If the Fast Update Rate is OFF, then currently your receiver is only capable of an update rate of 1 Hz
per second. Contact Technical Support to see if your receiver can be upgraded to a faster update rate.
Note: The settings shown on this GPS Information screen varies, depending upon your model of GPS
receiver.
Fast Update Rate and Everest Multipath are only available with TSIP receivers.
ONTRAC2 INFORMATION
Users of the OnTrac2 guidance system can also view the
OnTrac2 Information screen below, in addition to the GPS
Information screens discussed previously.
• OnTrac2 Vehicle
Displays active vehicle profile.
• ESC Firmware Version and ECU Firmware Version
Displays current firmware versions for OnTrac2.
• Steering Status
Displays either Good or Bad. If the MDU does not have power, it will display a message stating MDU Power
Error.
PARADYME INFORMATION
Users of the ParaDyme guidance system can also view the
ParaDyme Information screen (shown at the left) in addition to
the GPS Information screens discussed previously.
• Firmware Version
Displays ParaDyme firmware version.
• Serial Number
Displays ParaDyme serial number.
• Active Vehicle
Displays current steering profile.
• Steering Status
Displays either Good or lists system errors.
NTRIP INFORMATION
Users of the NTRIP guidance system can also view the NTRIP
Information screen below, in addition to the GPS Information
screens discussed previously
• Connect
Connects the display to the NTRIP correction source.
• NTRIP Stream
Network mount point.