Installation Sheet
T5L Under Cabinet Series Hardwired LED Undercabinet Fixture
Page 2 of 2 8060797
Limited Factory Warranty
AFX Inc. warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period
of 5 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does
not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
3. Hardwire Installation Completion
a. There are 3 wires that are in the wire channel that are used to connect the fixture
to the branch circuit.
b. Connect the Green ground input supply wire to the fixture Green ground wire.
Do this by inserting it into the open hole in the push-in wire connector (included)
that is attached to the Green ground wire in the fixture.
c. Connect the White input supply wire to the fixture White wire. Do this by
inserting it into the open hole in the push-in wire connector (included) that is
attached to the White wire in the fixture.
d. Connect the Black input supply wire to the fixture Black wire. Do this by
inserting it into the open hole in the push-in wire connector (included) that is
attached to the Black wire in the fixture.
( Do not mix wires or change polarity.)
e. Pull on each wire lead to make sure connections are secure. Make certain no bare wires are exposed outside of the wire
connectors.
f. Feed wires back into fixture, close wire channel, and attach the fixture to the base of the cabinet, with screws (2
& 3) as defined in mounting section.
5. Mounting
A. Using Keyhole slots to determine mounting hole location for this fixture (Ref Key hole Slots on Fig 4), position the fixture in location
intended for mounting. Mark hole locations by using the screw-holes as a guide. Drill suitable holes in the marked positions. Mount the
housing to desired surface with the 2 screws (included in parts bag). Reattach diffuser, and turn on the breaker for this branch circuit and
test the light fixture for proper operation, the light should operate as expected once you turn on the switch.