Instruction Manual
RNS Series LED Sconce Fixture
Models: RNS516
Page 1 of 1 8061006 R0
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local electrical
codes.
Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground connection
of your main power supply panel. The green ground screw location is
clearly marked on the gem bar.
This fixture is intended to be used for general indoor lighting in dry or
damp location.
Assembly Instructions
1. Preparing for installation.
A. Disconnect electrical power before installing or servicing any part of this fixture.
B. Separate fixture (1) from mounting bracket (7) place the fixture (1) and parts bag off to the side.
C. Assemble inner glass (2) to the fixture (1) with retaining cap (3) and secure firmly with screw (4).
D. Assemble outer glass (5) over the inner glass (2) by aligning bands to the hole on fixture (1) and secure
firmly with four barrel screws (6).
E. Install wall mounting bracket (7) with flat side facing the junction box (not provided) and secure firmly with
two long screws (8). For additional support, use two wood screws with drywall anchors (included) to
secure to the wall.
2. Wiring.
All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes.
If power supply wires are within three inches of driver use wire suitable for at least 90°C (194°F). Note:
Most dwellings built before 1985 have supply wire rated to 60°C. Consult a qualified electrician before
installing.
A. This unit will not operate properly unless connected to a “grounded” electrical circuit. Electrical shock,
overheating, low or no light output, and shortened lamp life can result if proper grounding is not done.
B. Make all wire connections to appropriate wire. Secure with wire nuts (supplied).
C. Connect green wire from the fixture to the power source green wire.
D. The white wire from the fixture is connected to the white (N) wire from power source.
E. The black wire from the fixture is connected to the black (L) wire from the power source.
F. Do not mix wires. Pull on each wire lead to make sure connections are secure. Make certain no
bare wires are exposed outside of wire connectors. Tuck all connections neatly into the junction box.
3. Fixture mounting.
A. Fixture can be mounted UP or DOWN depending on application.
B. Install fixture (1) carefully to mounting bracket (7) and secure firmly with two flat head screws (9).
4. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal
operating conditions for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends
only to replacement of defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or
damage incurred in transit.
UP APPLICATION SHOWN