Instructions / Assembly

LED Fixed Rail Luminaires Part #: 295326
Surface Mount
120VAC / 60Hz
Distributed by: To Reorder:
HD Supply Facilities Maintenance, Ltd.
Atlanta, GA 30339 1-800-431-3000
© 2017 hdsupplysolutions.com
Made in China
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring.
This fixture must be wired in accordance with all national and
local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp
surface or in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused
circuit and can be used in conjunction with listed 2-wire, triac
dimmers.
To reduce the risk of electrical shock, and to assure proper
operation, this fixture must be adequately grounded. To
accomplish proper grounding, there must be a separate ground
wire (green) contact between this fixture and the ground
connection of your main power supply panel.
This fixture is intended to be used for general indoor lighting in
dry or damp locations only.
Assembly Instructions
Step 1 - Preparing for installation
A. Disconnect electrical power at fuse or circuit breaker
box before installing or servicing any part of this fixture.
B. Carefully remove the fixture from the carton.
C. Remove round gem bar (2) from the fixture by removing
two screws (3).
D. Install round gem bar (2) to junction box (not provided)
by securing it with two machine screws (4).
Wiring - All wiring must take place inside junction box (not
included).
Caution: Make sure power is off at fuse or circuit breaker box.
Check power wires for damage or scrapes. Use wire suitable
for at least 90°C (194°F).
Note: Most dwellings built before 1985 have supply wire rated to
60°C. Consult a qualified electrician before installing.
Step 2 - Wiring
A. Make all wire connections to appropriate wire. Secure with
wire nuts (5), (supplied).
B. Connect the green or braided copper wire from the fixture to the
power source green wire.
C. The black wire from the fixture is connected to the black (L)
wire from power source.
D. The white wire from the fixture is connected to the white (N)
wire from power source.
E. Tuck all connections neatly into the junction box.
Step 3 - Install fixture (1) to round gem bar (2) with two screws (3).
Step 4 - Restore power at fuse or circuit breaker box.
Luminous Intensity Distribution