Instructions / Assembly

LED Vanity Luminaire Surface Mount
Model: JDV31500 120VAC / 60Hz
8060740 Rev 6
1 of 1
Limited Factory Warranty
Patriot Lighting warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective
fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) contact
between this fixture and the ground connection of your main power
supply panel.
This fixture is intended to be used for general indoor lighting in dry or
damp locations only.
ASSEMBLY INSTRUCTIONS
Step1. Preparing for installation-Fig.1
A. Disconnect electrical power at fuse or circuit breaker box before
installing or servicing any part of this fixture.
B. Carefully remove the fixture from the carton.
Step 2. Remove circular gem bar (1) from the fixture base by removing two
screws.
Wiring-all wiring must take place inside junction box (not included)
Caution: Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within three inches of
the ballast power supply, use wire suitable for at least 90°C (194°F).
Note: Most dwellings built before 1985 have supply wire rated to 60C.
Consult a qualified electrician before installing.
Step 3. Install circular gem bar (1) (supplied) on the junction box (not
supplied) by securing it with two screws (2) (supplied).
Step 4.
A. Make all wire connections to appropriate wire. Secure with wire nuts
(supplied).
B. Connect the green wire from the fixture to the power source green wire.
C. The black wire from the fixture is connected to the black (L) wire from
power source.
D. The white wire from the fixture is connected to the white (N) wire
from power source.
E. Tuck all connections neatly into the junction box.
Step 5. Place fixture base (4) over the gem bar, align two mounting
holes on both sides.
Step 6. Install fixture by securing the base with two screws (3)
(supplied).
For Diffuser install
A. Remove plastic retainer nut (6) from fixture base (4) by
turning the nut counterclockwise.
B. Install diffuser and re-install the plastic retainer nut (6) by
turning clockwise to secure diffuser (5).
LED module is non-replaceable from fixture.
Restore power at fuse or circuit breaker box.