User Manual

ManualsBrandsAFX LIGHT ManualsRGBWAFX LIGHT CLUB-MIX3 LED Par Can 19 x 10w RGBW

EN 4

2. Connection of Signal Cable

You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of

the slave light. Connect the DIGITAL OUT socket of the master and the IN socket of the slave light,

then, connect the OUT socket to the IN socket of the next light. Ordinal to connect all the lights as

below:

IN OUT OUTIN OUTIN

DMX IN

Resistor

Light

120Ω 1W

2 3

The connection between the output of master and input of product, it’s available to use the 3 pins

XLR cable which provided by the manufacturer. Signal cable from the DMX output of the controller

to the input of the rst master light, and connect to the DMX input of second slave light from the

DMX output of the rst master light, analogously, till connected all the slave lights, and insert the

last connector to the output of the nal light. (Notice: the diameter of core of every cable should

be 0.5mm at least, double core shelter cable should be used).The signal connecting must use the

attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch

to each other or connect to the connector.

A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR

connector with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector

CONTROL PANEL

Use Menu button to choose a function among MODE, SET, DMX, REST,

TEST and TEMP. Press Enter button to enter in the menu of the selected

function

Use Up and Down button to select the parameters then press Enter button

to set the selected parameter

Check the following function table :

MENU DESCRIPTION

MODE

ADDR

VALU A001~A XXX (AXXX) DMX address setting

SLAV Stand-alone mode (Slave mode)

AUTO IP1-8

ALON /(AU-A)

SP_1~SP_5 (Speed)

Internal programme (alone)

with speed control

MAST /AU-M)

Auto-run (Master) with speed

control

SOUN IP1-7

ALON (SO-A) Sound control (alone)

MAST/(SO-M) Sound control (Master)

SET

MIC M-XX Mic sensitivity setting

LOAD ON/OFF Reload data

VER V-x.x Software version

CALI

Code (password: 088) Input password

CH03-CH06 Calibration

DMX

MOD1 22CH

MOD2 10CH

REST ON/OFF Reset to factory default

DOWN

MENU ENTER

8.8.8.8.