User guide

Manual Issue 046 Ovation Systems Ltd. Page 27
Time-Lapse DVD Recorder
User Guide
Chaining Two AfterBurners:
Set a second AfterBurner to start recording
when the first unit’s hard disk is full.
● Connect record chain-out of unit 1 to
Chain-in and Wake-up of unit 2.
● The first unit’s “Set Disk Options” must be
set to “Stop When Full”. See Section 4.1,
page 13.
Chain-in 512
Chain-out
Wake-up 6
7 Ground Ground 7
Unit 1
Unit 2
Synchronise AfterBurner Internal Clock
With External Time Code Receiver.
● Connect time code receiver serial output
to pin 4, Time-in.
● In the “Set time & date” advanced menu
set “Time-sync” to the relevant format,
e.g. “UK-MSF”
● A second unit can be synchronised via
the Time-out pin.
7 Ground
Time Code
Reciver
Unit 1
Unit 2
4 Time-in
11Time-out Time-in 4
Optional
Time Code
Ground
5.3 Rear Panel Configuration Switches
a b c d
12 34
On
(on is down)
A Light Front panel backlight. ON = always on, OFF = on for 5 seconds after
each key press
B Aux: Not used.
C Lock: Front panel lock-out, see Section 4.9
D On. AfterBurner always on, disables the front panel STBY switch.
Afterburner firmware .046 www.ovation.co.uk