User guide

Manual Issue 046 Ovation Systems Ltd. Page 22
Time-Lapse DVD Recorder
User Guide
4.11 Set Configuration
Reset the AfterBurner system configuration to factory defaults and enable load-system-
configuration from CD or DVD disk.
Set Configuration
===================
Factory setup? No
Enable setup? No
Default values?: if set to “yes” and the ► key pressed, the unit’s system
configuration will be returned the factory default settings.
Load CD/DVD ini: if set to “yes” AfterBurner will attempt to load its system
configuration from the DVD in the drive the next time the drive is
accessed.
This mode allows a number of AfterBurners to be easily setup with
the same system configuration. From version 034 onwards,
AfterBurner burns its current system configuration as a small file to
each DVD. With the “Enable setup” mode activated, AfterBurner will
attempt to read and install the configuration from DVD next time the
DVD drive is activated (e.g. pressing the “DVD” key and inserting
an AfterBurner 034, or higher, disc). For more information, please
refer to the upgrade information on the website (see Section 7).
NB: This mode is automatically disabled after use and / or at power
down.
4.12 System Information:
System information:
Version: 04.01.4.024
Serial No. 00001113
See Section 7.1 for more information about the version number and how to upgrade the
system firmware.
Afterburner firmware .046 www.ovation.co.uk