User guide

Manual Issue 046 Ovation Systems Ltd. Page 13
Time-Lapse DVD Recorder
User Guide
4.1 Set Disk Options
Set disk options
===================
DSK: endless loop
Quick wipe: No
DSK: endless loop: (default) the unit fills the disk as it records. Once full,
AfterBurner then automatically overwrites the oldest data.
stop when full: stops recording when the internal disk is full (i.e.
no overwrite).
stop on unburnt: keeps recording to the hard disk in a loop
(overwriting the oldest data) until it encounters an un-burnt DVD
file.
Quick erase: (Yes/No) use the ▲ ▼ buttons to select yes and then ►twice to
invoke a quick disk erase that clears the file tables (takes about 10
sec).
Full erase: (Yes/No) use the ▲ ▼ buttons to select yes and then ►twice to
invoke a full disk erase, clearing all data on the disk (takes about
60 mins).
TIP: Unless security is of prime importance, quick erase is usually
sufficient.
Record Pause: On / Off (default off). Selects Record-pause mode where pressing
the record key whilst recoding causes the unit to enter record
pause. Pressing the record key for 2 seconds stops recording. See
Section 3.4, page 9.
Audio format: MPEG: (default) standard MPEG-1 layer 2 audio compression at bit
rate of 256 kbps.
LPCM: Linear pulse code modulation. Uncompressed audio (16 bit,
48kHz sampling) with a bit rate of 1.536 Mbps.
AC-3: Dolby digital audio compression, bit rate 256 kbps.
NB: LPCM and AC-3 may have problems with playback on certain
players, especially in “high” and “very high” video quality modes.
Auto Shutdown: Smart: (default) AfterBurner will stay on unless a timer is active
when it will enter stand-by after 5 minutes of idle operation.
On: AfterBurner will enter standby after 5 minutes of idle operation.
Off: AfterBurner will not enter standby.
Afterburner firmware .046 www.ovation.co.uk