Instructions / Assembly

HowtoHangaBeerCapMap
Hanging your new beer cap map is quick and simple using the
predrilled holes! All you need is a hammer & finishing nails.
FOR WOOD OR DRYWALL:
● Position your beer cap map on the wall in your desired location.
● Use a pencil to make a mark through the included nail holes.
● With a hammer, tap in finishing nails through the marked locations, leaving ¼ inch protruding.
● Place your beer cap map over the ends of the finishing nails.
FOR BRICK OR CONCRETE:
● Position your beer cap map on the wall in your desired location.
● Use a pencil to make a mark through the included nail holes.
● Drill a pilot hole and insert a plastic anchor into the hole.
● With a hammer, tap finishing nails into the anchors, leaving ¼ inch protruding.
● Place your beer cap map over the ends of the finishing nails.
© After 5 Workshop, 2017