User manual

8
Oven must be mounted on a flat horizontal surface.
In order to ensure adequate ventilation, the back panel of the cabinet must be
removed to ensure a gap at least 50mm at the rear.
ELLECTRICAL INSTALLATION AND POWER CONNECTION
Installation must comply with SAA Wiring Rules and with local electrical and
building regulations.
Notice to Electrician: Please ensure sufficient supply cable is provided to
allow oven to be pulled clear of the cavity should any service work be
necessary. This will also allow easy connection of supply.
The oven must be supplied with proper voltage and frequency (AC220-240V,
50Hz), and connected to an individual, properly grounded branch circuit,
protected by a circuit breaker. Electrical load of the oven is 2145W.
Wiring diagram located at the back of the oven.