User's Guide

25
Transferring Results to a PC via USB
To transfer les from your FlexScan to a PC using a USB cable, perform the following:
• Connect your FlexScan to a PC using the supplied micro-USB to USB cable. Make sure the micro-plug is fully
seated in your FlexScan.
• Touch the USB soft key on the Results Scree.
• On your PC, open My Computer. A new removable drive named TS100 X: will appear, where ‘X:’ is the drive
letter assigned to your FlexScan.
• Under TS100 X: you should see two folders: RESULTS and SOFTWARE.
• Copy the RESULTS folder to your PC.
– Under RESULTS you will see: TRACES.
– Under TRACES you will see all of the folders containing test results.
Note:
Before removing the USB cable connecting your FlexScan to your PC, or pressing the Cancel soft key on the USB
screen, left click the Safely Remove Hardware icon in the Start bar of your PC, then left click the Safely remove USB
Mass Storage Device – Drive (X:) message, where ‘X’ is the drive letter assigned to your FlexScan.
Back Up Saved Results to USB Memory
To back up internally stored results to USB memory stick, plug external USB memory stick into FlexScan and
perform the following steps
• From the Test screen, press the Home/Menu button, and then touch My Projects
• If Folder Up icon is shown, touch it to navigate up to Projects level until icon disappears.
• Verify that Internal Memory is currently selected - memory card icon is shown.
• If USB selected, touch USB memory icon to toggle to internal memory.
• Touch Menu icon.
• Touch Backup.
• Wait until “Writing backup to USB drive…” completes.