User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Labeling and Hazard Warning
- Hardware Overview
- User Interface Overview
- FleXpress® Fault Locate Test Setup
- General Settings
- Live Fiber Detection and Launch Quality Check
- Live PON Test
- LinkMap Display and Navigation
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Probe and FlexScan
- File Manager
- Transferring Results to a PC via USB
- Back Up Saved Results to USB Memory
- How to View Device Information
- General Information
23
Manually Saving Results
• While in the Results view, touch Menu icon.
• Touch Save As.
• Edit Project, End1, End2, Cable and Fiber# names used to identify saved results: touch any eld to edit it. Touch
Done when nished.
• Touch [Save To] to view, navigate and select destination memory, Project, or Fiber Group folder. Touch Back to
return to Save As screen.
• Touch Done to save test results.
Saving to a Newly Created Folder
• While in the Results view, touch Menu icon.
• From the displayed sub-screen, touch Save As to display the Results Manager screen.
• Dene Project, End1, End2, Cable and Fiber# elds used to name saved results. Touch Done when nished.
• Note: this will make the newly created Project, End1, End2, Cable, or Fiber current.
Saving to the Current Folder
• While in the Results view, touch the Menu icon.
• From the displayed sub-screen, touch Save As to display the Results Manager screen.
• Review Project, End1, End2, Cable and Fiber# names used to identify saved results. Touch Done when nished.
Auto-saving Results
TS100s may be congured to automatically save test results each time an OTDR test is completed. Auto-save (and
optional auto-send) are congured in the General Settings screen, as follows:
1. From the General Settings screen, touch the [Auto-Save & Send] control.
2. Select the desired auto-save/send option:
– Auto-saved Disabled: Results will not be automatically saved.
– Auto-save Only: Results will be saved using the congured Project, End1, End2, Cable and Fiber#. Fiber# will
be auto-incremented after each test completes and the results are saved.
– Auto-Save & Send: Results will be saved using the congured Project, End1, End2, Cable and Fiber#. Fiber#
will be auto-incremeanted after each test completes and the results are saved. Saved results will be sent to a
Bluetooth-paired Android or iOS device running the FlexScan App. If no device is paired, enabled and within
range, or if TS100's Bluetooth is disabled, results will not be sent or will timeout.
3. After selecting Auto-save Only or Auto-Save & Send, congure the Project, End1, End2, Cable and Fiber# as
described above.