User's Guide

21
Conguring Auto-Send
• From the Main Menu, select Settings.
• Select Capture to display the Capture settings screen.
• Highlight and Select Auto-Send.
• Use Arrow Keys to enable Auto-Send on 1st Capture key or on 2nd Capture key.
When Auto-Send is enabled, pressing Capture key from Live Image mode will initiate auto-focus (if enabled),
capture image, analyze pass/fail (if enabled), then send image and pass/fail results to paired FlexScan.
Inspecting Optical Connectors
Once FlexScan is paired to FOCIS Flex with Bluetooth enabled on both units, perform the following steps.
On FOCIS Flex:
• If testing an optical ber connector, slide the ferrule of the optical ber into the adapter tip installed on the
FOCIS Flex inspection port. Use caution not to contaminate the end-face of the ber connector.
• If testing an optical ber connector mounted in a bulkhead adapter, slide the adapter tip into the bulkhead
adapter.
• You will see a Live ber-end image appears on the FOCIS Flex display.
• Capture the displayed image by pressing the Capture button. (Refer to section "FOCIS Flex Inspection Probe Overview"
on page 19).
• Once captured, the ber end-face image is analyzed by the FOCIS Flex.
• Once analysis is done, inspection results will appear on the FOCIS Flex display.
• Simultaneously, FOCIS Flex will be sending results to the FlexScan paired to it.
Notes:
1. Touch left/right arrows to select image only, overlay only, or image + overlay
2. Touch Menu to select Test/Home screen Menu.
– Allows user to Save or Send OPM results, select General Settings, etc.
3. Press Back or Home button to return to the previous screen.
1
2
3
3