User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Labeling and Hazard Warning
- Hardware Overview
- User Interface Overview
- FleXpress® Fault Locate Test Setup
- General Settings
- Live Fiber Detection and Launch Quality Check
- Live PON Test
- LinkMap Display and Navigation
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Probe and FlexScan
- File Manager
- Transferring Results to a PC via USB
- Back Up Saved Results to USB Memory
- How to View Device Information
- General Information
18
Light Source and Power Meter Operation
Light Source Settings and Features
1. Touch Laser On/Off to enable/disable light source. RED Laser indicates that source is ON.
2. Touch Modulation eld to select source modulation: Wave ID, CW, Tone (270 Hz, 330 Hz, 1 kHz, 2 kHz).
– Select Wave ID mode for fastest loss measurements. While in this mode, the FlexScan source transmits
wavelength information, enabling a Wave ID power meter to synchronize and measure power at
received wavelength(s).
– Use CW mode to generate continuous wave light at a single wavelength for loss measurements with non-Wave
ID power meter.
– Generate Tone for ber identication (270 Hz, 330 Hz, 1 kHz, 2 kHz).
3. Touch Wavelength eld to select test wavelength.
Power Meter Settings and Features
4. If used with non-Wave ID source, touch to select wavelength. If used with Wave ID source, power meter
automatically synchronizes to and indicates received wavelength(s).
5. Touch and hold Ref/Set to store new reference(s) at received wavelength(s). Touch and release Ref/Set to view
stored reference(s).
6. Touch dB/dBm to toggle between power (dBm or Watts (mW, μW, nw)) and loss (dB) mode.
– Power meter detects and indicates ber identifying tones when used with a light source capable of generating
a modulated Tone signal.
Notes:
7. Touch Menu to select Test/Home screen Menu.
– Allows user to Save or Send OPM results.
8. Touch Back to return to the previous screen.
1
2 3
4
5
6
8
7