User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
50
To transfer les from your FlexScan to a PC using a USB cable, perform
the following:
• Connect your FlexScan to a PC using the supplied micro-USB to USB
cable. Make sure the micro-plug is fully seated in your FlexScan.
• Touch the USB
A
soft key on the FlexScan’s Home screen.
• On your PC, open My Computer. A new removable drive named FS200
X: will appear, where ‘X:’ is the drive letter assigned to your FlexScan.
• Under FS200 X: you should see two folders: RESULTS and SOFTWARE.
• Copy the RESULTS folder to your PC.
– Under RESULTS you will see: TRACES.
– Under TRACES you will see all of the folders containing OTDR
traces or OPM results.
Note:
Before removing the USB cable connecting your FlexScan to your PC,
or pressing the Cancel soft key on the USB screen, left click the Safely
Remove Hardware icon in the Start bar of your PC, then left click the
Safely remove USB Mass Storage Device – Drive (X:) message, where ‘X’
is the drive letter assigned to your FlexScan.
Transferring Files to a PC via USB
Home Screen
A