User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
5
Safety Information
WARNING! Use of procedures or adjustments other than those specied herein may result in hazardous radiation
exposure.
1550 nm OTDR/OLS port
1650 nm OTDR/OLS port
1310/1550 nm OTDR/OLS port
1310/1550/1650 nm OTDR/OLS port
This is a CLASS I LASER output.
VFL port This is a CLASS II LASER output. Do not stare into beam!
NOTE! FlexScan OTDRs equipped with Bluetooth (option W1) contain the following Bluetooth Transmitter Module:
FCC ID: X3ZBTMOD8
IC: 8828A-MOD8
NOTE! FlexScan OTDRs equipped with WiFi contain the following WiFi Transmitter:
FCC ID: 2ANTH-FS2TS1
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modications not expressly approved by AFL Test and Inspection could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful