User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
43
Once FlexScan is paired to FOCIS Flex with Bluetooth enabled on both units, perform the following steps.
On FOCIS Flex:
• If testing an optical ber connector, slide the ferrule of the optical ber into the adapter tip installed on the FOCIS
Flex inspection port. Use caution not to contaminate the end-face of the ber connector.
• If testing an optical ber connector mounted in a bulkhead adapter, slide the adapter tip into the bulkhead
adapter.
• You will see a Live ber-end image appears on the FOCIS Flex display.
• Capture the displayed image by pressing the Capture button. (Refer to section “FOCIS Flex Inspection Probe
Overview” on page 39).
• Once captured, the ber end-face image gets analyzed by the FOCIS Flex.
• Once analysis is done, inspection results will appear on the FOCIS Flex display.
• Simultaneously, FOCIS Flex will be sending results to the FlexScan paired to it.
Inspecting Optical Connectors