User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
37
1. Touch to enable/disable light source. RED dot indicates that source is ON.
2. Touch to select test mode: Wave ID, CW, Tone (270 Hz, 330 Hz, 1 kHz, 2 kHz).
– Select Wave ID mode for fastest loss measurements.
While in this mode, the FlexScan source transmits wavelength information, enabling a Wave ID power meter
to synchronize and measure power at received wavelength(s).
– Use CW mode to generate continuous wave light at a single wavelength.
– Generate Tone for ber identication (270 Hz, 330 Hz, 1 kHz, 2 kHz).
3. Touch to select test wavelength: 1310, 1550 or 1650 nm (depending on model).
1
2
3
Light Source Settings and Features
Light Source and Power Meter Operation
1 2
3
Light Source Settings
Power Meter Settings