User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
27
Initiate the SmartAuto test by touching ‘Press to start’
A
soft key or
pressing Test start/stop button.
1. FlexScan begins testing with the Live Fiber check and if a live ber is
NOT detected, proceeds to next step.
2. If the Launch Quality check is enabled
B
, FlexScan checks loss and
reectance of the OTDR connection.
3. If launch quality is ‘Good’, FlexScan starts testing at both wavelengths
using SmartAuto settings.
4. When testing is completed, FlexScan displays the LinkMap
®
screen,
which is a primary display in SmartAuto OTDR mode.
Testing in SmartAuto
®
OTDR
Live Fiber Detection
To Start SmartAuto Test
To prevent service disruption on live PONs, FlexScan performs a Live Fiber
check prior to every OTDR test. If a live ber is detected,
FS200-50B/100/300 models display a warning screen and do not allow
testing; FS200-60/-304 displays a warning
C
and allows the user to
complete a test at 1650 nm only.
C
A
B