User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
19
To configure automatic MPO Switch control:
• Touch Switch Mode
A
.
• A popup error message appears if Switch Mode selected with
no MPO switch connected and enabled.
• Switch Settings
B
appears if switch connected and
enabled.
• Select Auto Switch Mode
C
.
• Select Next Fibers
D
and congure bers to be tested.
• Touch Auto-save to Folder
E
, then select and congure
Job,OTDR End, Far End, Cable folder, and start Link (Fiber#)
where multi-ber test results will be saved.
General Settings
A
B
E
C
EC
D
D