User's Guide
Table Of Contents
- Safety Information
- Apple Inc. Legal Notice
- Hardware Overview
- User Interface Overview
- General Settings
- SmartAuto® OTDR with FleXpress™ and LinkMap® Display
- Testing in SmartAuto® OTDR
- Understanding Expert/Real-time OTDR Settings
- Expert OTDR Settings
- Real-Time OTDR Settings
- Testing in Expert and Real-Time OTDR Mode
- Light Source and Power Meter Operation
- Inspecting Fibers with FOCIS Flex and FlexScan
- Saving, Recalling and Uploading Test Results
- How to View Device Information
- General Information
11
You may charge the battery while your FlexScan is switched on or
off by attaching the supplied AC charger.
• Plug the included AC charger into AC outlet.
• Connect charger plug to the Power port
1
.
• AC/Charger indicator
2
will illuminate to indicate charging
status as follows:
RED - Charging battery
GREEN - Fully charged
OFF - AC disconnected
• FlexScan charges while operating.
When FlexScan is ON, battery icon shown on the display indicates battery status as follows:
- Battery fully charged
- Battery partially charged
- Battery discharged
- Battery charging
Battery fully charged, Battery partially charged, and Battery discharged symbols will only be shown when unit is
operating without being connected to AC.
Battery Charging
Understanding Battery Charge Status
• A fully-charged battery operates for approximately 12 hours of typical use.
1
2