User's Guide
Table Of Contents
- Safety Information
- Standards Compliance Information
- General Information
- FOCIS Lightning Overview
- Getting Started
- Main Menu and Settings
- Saving Captured Images
- Viewing Saved Results (Results Manager)
- Using FOCIS Lightning with FOCIS Flex App
- Sharing Captured Test Results
- WiFi-based Inspection File Access on FOCIS Lightning
13
Capture Button Operation
Inspecting MPO Connectors
• In the Live Image mode, press the Capture button to perform the following:
– Auto Focus image (if the Auto Focus option is enabled)
– Capture the displayed image and enter the Captured Image mode
– Analyze image (if the Pass/Fail option is enabled)
– Save results and send image to Bluetooth-paired device (if auto-save and auto-send enabled on
‘1st Capture Key’, see “To Congure Auto-Save and Auto-Send” on page 19 for details)
– If auto-save or auto-send enabled on ‘2nd Capture Key’ (see “To Congure Auto-Save and Auto-
Send” on page 19), press the Capture button again to save and/or send
• In Captured Image mode, press the Capture button to return to Live Image mode.
• In the Main Menu or Settings modes, press the Capture button to return to the most recent Live or
Captured Image mode.
Getting Started
1. Plug male (pins) or female (holes) MPO cable into appropriate MPO alignment sleeve (“bulkhead”),
with adapter tip appropriate for the cable type.
2. Plug FOCIS Lightning adapter tip into the MPO alignment sleeve.
3. Turn on FOCIS Lightning (press the Power button on top).
4. The full MPO end-face in “1+2” view mode will be displayed on the FOCIS Lightning display In less
than two seconds.
5. Press the Capture button to initiate ber inspection and analysis.