Quick Start Guide V 0.1 ¥ Download full user manual at www.afinia.
Index Unpacking 1 Install Printer and External Spool Holder 2 Install Software 3 Load Filament 4\5 Setup Wi-Fi 6 Load and Print Model 7
Unpacking 1\ After unboxing the machine, remove the cushions inside the printer. 2\ Open the front door and remove the top lids. ¥ 3\ Find the print head in the accessory box.
Install Printer and External Spool Holder 1\ Align the print head to the slots in the print head mount. 2\ Slide the mounting plate into the slots and plug in the rainbow cable. 3\ The print head must be pushed to the bottom of the mount. Notice: When installed correctly, the red and blue shaded parts should be at the same level.
Install Software and Connect to Printer 1\ Please go to www.afinia.com/support/downloads to download the Studio software and install it on your computer. ¥ Afinia 3D Studio Software 2\ Connect the printer to your computer. 3\ Automatic nozzle height detection. Rear View ① Click the “Initialize” button to initialize the printer. ② Click the “Calibrate” button. Auto Power switch ③ Click “Auto” to automatically detect the nozzle height.
Load Filament 1\ Put filament into the external spool holder and insert filament into the guiding tube. 3\ Insert filament and guiding tube into the machine through the hole on the back door. Guiding Tube Make sure the section of guiding tube inside the machine is no less than 28 cm. Filament Spool Rear View 2\ Put the guiding tube into the rubber ring. 4\ In the material page, press the circular material button to switch between different materials.
6\ Gently push the filament into the filament entrance and down until it stops. After reaching the print temperature, the printer will beep and start extruding filament. 7\ Push the guiding tube into the filament entrance and insert the tube into the holding clip on the mount. lock the guidng tube at the tube holder Insert guiding tube into the filament entrance Filament extrusion 9\ 8\ Close the top covers and doors.
Setup Wi-Fi 1\ 2\ Make sure the Wi-Fi field option is “ON”, Click the “Config” button. then click the Wi-Fi button in the upper right corner. AFINIA H400 3\ Click on the top right corner of the search key to search for your Wi-Fi network. 4\ Choose a Wi-Fi network in the list. It needs to be the same as your computer’s network. your_network your_network1 your_network2 your_network3 your_network4 5\ Click the password field to input your Wi-Fi password. your_network 7\ Click the “connect” button.
Load and Print 3D Models 1\ Connect the printer to the computer via USB or Wi-Fi. 2\ Click the “Build” button at the main menu to enter the print setup interface, click “+” button to load a file (image or STL/UP3 file). Build 3\ Use the adjustment wheel to setup the print job. 4\ Click “Print”. 6\ 5\ Slicing and data tramission progress will be shown on the status bar. ¥ When the data transmission completes, the amount of time and material needed for the print job will be shown.
¥ Afinia 3D 8150 Mallory Court, PO BOX 846 Chanhassen, MN 55317 youtube.com/afinia3dprint Phone Support: 952-279-2643 Support: support@afinia.com Web: www.afinia.
