User manual

13
D
HEATSINK C
value
Value means controller internal temperature. If
displayed value exceeds 92-Celsius degrees the
controller will enter the thermal protection.
THROTTLE %
value Value means percent of applied throttle.
SPD LIMIT POT
100 Constant value 100.
Faulty system or controller if different than 100.
BATT VOLTAGE
value The actual total battery voltage when throttle is
applied
BDI
value Value means percent of battery remaining capacity.
Full charged battery means 100%
MODE INPUT A
ON OFF The reading could be ON or OFF depending of
Low /High SPEED switch
REVERSE INPUT
OFF Constant value OFF; not used in application
INHIBIT IN
OFF ON The reading could be On or OFF.
When reading is ON the drive is inhibited
EM BRAKE DRV
ON OFF The reading could be On or OFF. With throttle
applied the value is ON. When releasing the throttle
the value is changed to OFF
MAIN CONT
ON OFF Displays the status of the main relay located in the
controller. With throttle applied the status should be on.
If it remains off the controller has detected a fault and
the driving is inhibited
MOTOR R
400 Constant value
PUSH ENABLE IN
OFF OFF; not used in application
Before tests enter the Programming mode and change the parameter THRTL
AUTOCAL from OFF to ON.
Other alternative is putting the vehicle’s front wheel in freewheeling mode.
E LOW /HIGH SPEED SW
Turn the switch into Low Speed position. The switch’s lamp is off. The LCD shows
MODE INPUT A OFF. Turn the switch into High Speed position. The switch’s lamp
glows. The LCD shows MODE INPUT A ON.
F INHIBIT TEST
Plug in the charger’s DC outlet into the charging socket. Panel display turns off.
The handheld programmer LCD shows that INPUT IN was changed from OFF to ON.
Take out the charger’s plug and turn the motor cap knob to release the parking brake.
The horn warns continuously and the LCD shows INPUT IN ON. The panel display
works normally indicating the battery remaining capacity and controller status.
G Throttle mechanical and electrical span test
Squeeze the throttle (operation lever) in either direction. You should notice:
9 the motor turns forward or reverse direction
corresponding which way you operate the throttle.
9 the motor should run proportionately faster with
increasing throttle.
9 the handheld programmer’s LCD shows:
MAIN CONT ON
EM BRAKE DRV ON
THROTTLE % increasing and decreasing value shown
9 ensure that at maximum lever’s mechanical travel the reading is 100%
H Battery voltage reading
While throttle is applied the handheld programmer’s LCD shows the total voltage
battery.