User manual
24 
operate respectively. 
A warning buzzer may also be sounds (in certain models only and subject 
to local ordinances). 
Horn/Buzzer 
Push one of the 2 Buttons (1.9) to activate the buzzer. 
The buzzer sounds automatically under the following conditions (subject to 
change where prohibited by law): 
1. When reversing. 
2. When operating the “Turn Signal” (Right or Left). 
Remark: It is possible to change the Buzzer Functioning by changing a Dip 
Switch in the front Board .This needs to be made by a trained technician. 
Headlight Switch 
Turn on the Headlight and rear lights by pushing the Light button (1.15). 
This button activates both the Headlight and the Rear Lights. 
When Lights are activated the Light Led (5.6) is lit. 
To turn off the lights , push the button again. 
Hazard Warning 
The  Hazard  Button  (1.17)  operates  all  flashing  lights  on  the  Breeze  S. 
Pushing the button once turns the all the lights ON blinking. 
A second push turns them OFF. 
When Hazard is activated both signals (5.3+5.4) are Flashing. 
Charge Inhibit 
When  the Vehicle  is being  charged it  is inhibited. In this  condition no 
driving can be done. When being charged ON condition the signal (5.13) 
will lit. 
Safe driving 
When driving on Ramp , Steep Curbs and turns drive the Breeze S very 
slowly and carefully , even consider changing the Half Speed Switch (1.2) 
to Half speed mode. 
When going up or down a step always drive the Breeze S so that the 
wheels will get in perpendicular direction to the step and the rear wheels 
wheel climb or go down together. 
Never try to go on an obstacle that is more than the maximum 
recommended slope angle and curb climbing. Maximum rates are in the 
specification sheet. 
Always drive carefully, adjust the speed according the limitation of 
the road. 
Before making sharp turns , reduce the Breeze S speed to Half Speed 
to prevent side roll-over. 
Parking 
After stopping, turn the Main Key Switch (1.11) to OFF and remove the 
key. The LCD will turn OFF. The Electromagnetic Brake is engaged 
(locked). 
Note: The Electromagnetic Brake is automatically locked whenever 
the Operating Lever is released and after the Breeze stops 
completely. 










