Operation Manual

``
23
(Numbers refer to Figures 6 and 7)
Adjusting the
ha
ndbrake
(1.12)
The handbrake cable mechanism can be adjusted by an authorized
Breeze technician or
dealer,
or by any professional authorized to adjust
handbrakes mounted on bicycles or motorcycles.
The
handbrake is part of your safety system. DO NOT adjust it
yourself—get professional assistance! The handbrake is optional.
Speed limit dial
(1.11)
The speed limit dial is located on the handlebar panel.
·
When the speed limit dial is set to MAX, the Breeze C
will drive at
10 km/hr or 12 km/hr or 15 km/hr, depending on the model.
·
When the speed limit dial is set to MIN, the Breeze C
will drive at
approximately 3 km/hr.
Do not
change the speed limit dial setting while the Breeze C is
moving
.
Note:
Set the
speed limit dial to MIN:
·
Until you get used to driving your new Breeze C, and
· When driving the Breeze C inside a building or in a crowded area
Full (1) - Half
(1/2) Speed
mode Switch
(1.11a)
Set the maximum speed of the scooter to half (1/2) or full (1) speed.
Use the 1/2 speed mode when dri
ving in close and crowded areas.
Throttle control
lever
and
m
anual
hand
brake
(1.12)
To drive:
Gently
squeeze the throttle control lever (1.3a or 1.3b
, depending on
whether you want to drive forward or backward
) until you reach the
desired speed.
Your speed is directly proportional
to the deflection of
the
throttle control lever.
Note:
You can squeeze one side of the
throttle control lever
towards you, or
you can push the other side away from you to achieve the same effect.
Use whichever method is most comf
ortable for you.
To stop
:
R
elease the throttle control lever. The Breeze C will stop gradually.
Note:
You can also use the manual handbrake for emergency stopping.
Indicator
buttons (left and
right)
(1.15)
Before you turn, press the applicable indicator button. When a turn
indicator
is activated, the applicable LED (5.3 or 5.4) will flash.
Depending on the model, a buzzer may also sound (subject to local
regulations).
To turn off the indicator, press the button again.
Buzzer buttons
(1.14)
To activate the buzzer manually, push one of the two buzzer buttons.
The buzzer sounds automatically under the following conditions
(except
where prohibited by law, or where your Breeze C
is modified
by a trained technician
; on request; contact your dealer for details):
1. When reversing
2. When o
perating the left or right indicator
3. Alarm conditions generated by the controller
Button for
headlight and
rear lights
(1.13)
To turn on the lights (headlight and rear lights), press the Lights button.
When the lights a
re on, the Light LED (5.6) is lit.
To turn off the lights,
press the button again.