Operation Manual

``
22
CHAPTER 6 – OPERATING INSTRUCTIONS
Figure 6 Figure 7
(Numbers refer to Figures 6 and 7)
Key switch
(1.17)
§ The main key switch is located on the tiller panel at the top of the
handlebar column (1).
The
key switch has two positions:
§
OFF: The Breeze C cannot be driven and the EMB is locked.
§
ON: Power is supplied to the Breeze C and the EMB is released
automatically when the throttle control lever is squeezed.
To operate the
Breeze C, insert the key in the key s
witch and turn it to
ON (clockwise). The switch will remain in this position and
the green
LED (5.2)
will be lit.
Note: The key switch is used to operate the Breeze C, not for locking.
Automatic shut
off
(optional)
This is an optional feature. When the key switch is ON, after a period of
time during which
the throttle control lever is
not used (the period is
programmed at the time the option is installed, and is usually 20
minutes)
, the control system will automatically
shut off to save battery
charge
. In the case of automatic shut-off, turn the key switch
OFF and
then ON again.
Battery status
Indicator
(5.1)
The battery status indicator is located on the tiller panel and shows you
the remaining capacity of the batteries.
Like petrol gauges in cars,
the
indicator is not absolute
ly accurate; it is merely a guide to help stop
you
running
out of fuel. The accuracy of the indicator also depends
on the
type and age of the batteries.
When the indicator
is in the yellow area
, recharge batteries as soon as
possible.
When the indicator
is in the red area
, recharge immediately. When the
indicator
is in the red, you can only drive a short distance (1-
4 km on
level surface).
Fault indicator
(5.2)
The ON LED indicator is also uses as a fault indicator. When the LED
is flashing,
it blinks the
code of the fault. (See Maintenance Manual for
the codes).